One day you walk past the back of your Roadtrek and you look down at the center of the bumper and you discover that the cover that goes over the opening to the propane tank fill and off/on knob is GONE! Forget about trying to find a new one. If you could it will cost you more than you should spend. There is an easy way to replace that cover with a simple DIY project that only requires a trip to a home store like Home Depot and a decent pair of scissors.
This is what you have lost -
CLOSE UP -
A very similar cover to the original can be easily made with some bathroom rubber wall cove base. This is sold on a roll at Home Depot or Lowes. It comes on a roll or you should find it to cut to length by the foot at the store. You don't need a lot - two feet is enough to make two - spares are good to have. Black blends with the bumper but it comes in other colors as well. You don't want it thick so look for one that is thin.
This is what rubber wall cove base looks like:
It can be cut with a good pair of scissors. Use the measurements of the opening combined with the turn latches at the center of each side that hold the cover in place. The height of the cove base should be fine as it comes. All you have to measure is the width you need it to be for the cover. Not much has to be done to the cove base other than cut it to size and cut notches for the turn latches to fit into so that they turn to hold the new cover in place. This comes with a lip at the bottom - just like the original cover has. It sits on the bumper the same as the original and is just about the same height as the original. The cove base comes two ways - with adhesive on the back and without - you want it WITHOUT ADHESIVE. Once you make it, it is going to attach exactly the same way the original did. It will fit in the space between the two turn latches. Set it in place with the slots over the open latches on each side. Turn the latch into the cover. If the latch does not fit, trim the slots for the latches so that they turn easily over the rubber. It may be tighter than the original but that is OK as it will be harder to open on its own and get lost.
For anyone who has not lost their cover - use the original to make a template which will make creating a new one even easier. Don't put it off - as it is even easier if you have the original to use a template - before you lose the original.
AND when you have the new cover on you should make a leash for it so that it will not get lost again. All you need to do is put a small hole in the corner and take a length of strong nylon fishing line through the hole and tie the ends around one of the brackets along the bumper just inside. Make the fishing line long enough to be able to take the cover off and sit it out of the way on the bumper or hang off the bumper when filling the propane tank.
For a few dollars and very little time you have a new cover!
No comments:
Post a Comment